Locking by Rolling!

WUKO Lock’n’Roller 1040


Tool for closing the single-lock standing seam 

  • Closes the profile in both directions
  • Clever system of eccentric lever with disc springs
    adjustment of the pressure if necessary > clean and precise result regardless of material
  • Simple removal of the tool from seam by relieving pressure – at any time and without scratching
  • Ergonomic handholds above and on both sides of the tool
  • Forming rollers of stainless steel
  • Rope-tying device included
  • Carrying case included


Technical Data

  • Maximum sheet metal thickness:
    Galvanized steel: 0.65 mm / 0.025″
    Aluminium, copper, zinc: 0.80 mm / 0.031″
    Stainless steel: 0.50 mm / 0.020″
  • Width of the profile: 12–15 mm / 0.47″-0.59″
  • Tool length: 270 mm / 10.6″
  • Weight: 2.9 kg / 5 lbs

How it’s done

  • Close a short piece of seam e.g. with pliers
  • Place the WUKO Lock’n’Roller on the seam, adjust to seam width, fix with wing screws
  • Move the WUKO Lock’n’Roller forward (using handholds, handle bars or rope)
  • If necessary increase or reduce contact pressure with the eccentric lever
  • Removing the WUKO Lock’n’Roller from the seam

    • drive out at the end of the seam
    • at any time by opening the eccentric lever (relieving of pressure) and loosening the wing screws
    • bring back to the beginning of the seam

For specialists: BATTEN SEAM

Just combine two holders of forming rollers.